6
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
ADJUSTING SANDING ARM ANGLE
1.
Disconnect air supply from
the tool to prevent acciden-
tal starting and potential
injury while adjusting the
Abrasive Belt Arm Angle.
2.
Using the included 4mm
Hex Key, loosen the Angle
Adjusting Screw located
on the upper side of the
Abrasive Arm Assembly
(FIG 5)
, rotate Arm to
desired position then
tighten screw securely.
ADJUSTING ABRASIVE BELT TRACKING
1.
Disconnect air supply from
the tool to prevent acciden-
tal starting and potential
injury while adjusting the
Abrasive Belt Tracking. The
Tracking Adjustment Screw
is located at the outer right
side of the Abrasive Arm
Assembly
(FIG 6)
.
2.
Using the included 1.5mm
Hex Key, turning the screw
clockwise (as viewed from
the right side) will cause the belt to track left while turning the screw counter-clockwise
will cause the belt to track right.
FIG. 5
FIG. 6
