To order parts and supplies: 800.345.1178 >> eastwood.com
5
SET UP & CONNECTION
WATER CONNECTION
1.
Connect Water Hose to Water Inlet
of Sander by pushing it into the
Compression Fitting until it seats
fully
(FIG 1)
. To remove Water Hose,
release it by pushing in the red plastic
ferrule while pulling out hose.
2.
Attach opposite end of Water Hose to
the Water Pickup Assembly by pushing
the Hose end with the Rubber Sleeve
fully over the Barbed Nipple
(FIG 2)
.
AIR CONNECTION
1.
Wrap white thread sealing tape (not included) around the threads of the 1/4" Male NPT Air Inlet
of the Sander Body. Then thread the 1/4” Female NPT Quick Disconnect Fitting (included), onto
the inlet threads of the Sander Body
(FIG 1)
.
2.
Attach Air Supply to Inlet Fitting.
FIG. 1
FIG. 2
Be sure that the air supply to the
tool is clean and dry. Moisture
in the supply line will quickly
damage the air motor and valves.
A minimum 3/8” I.D. air line
should be used for optimal
performance.
Air
Connection
✓
Water
Connection
✓
