10
Eastwood Technical Assistance: 800.544.5118 >> [email protected]
VERTICAL SETUP
To setup the Bandsaw for vertical cutting operations the following steps
must be taken.
1.
Unplug Bandsaw.
2.
Raise Bandsaw Head to the Vertical position and lock in place with
the latch and safety pin
(FIG. 8)
.
3.
Remove the two screws fastening the blade guide cover and remove
cover.
4.
Install Vertical Cutting Table and fasten with previously removed
screws
(FIG. 9)
.
5.
Install the table support bracket with pre-installed hex bolt and
a M6X12 flat head screw, washer, and nut.
6.
Use the adjustment bolt to level the cutting surface as needed.
VERTICAL OPERATION
1.
Ensure that the work piece and Bandsaw are stable and there are no obstructions in the path of the cut.
2.
While keeping both hands on the work piece in a safe location, gradually feed the workpiece into the blade while applying downward pressure.
Do not force the tool.
3.
Turn saw off immediately after each cut.
• Thoroughly read and understand these product
instructions before using the Bandsaw.
• Inspect tool before each use for loose or broken
components. Do not use tool if any components are
damaged.
• Turn saw off and Unplug when not in use to avoid
accidental starts!
• Do not force the machine when cutting material.
Excessive force applied to the saw can cause the
blade to break!
• Always wear ANSI approved eye protection while
operating this tool.
• This tool can emit excessive noise while operating.
Wear hearing protection while in use.
• Fine dust can be created by the cutting process.
Wear NIOSH approved respiratory protection while
operating.
• Moving parts can be dangerous! Do not wear loose clothing, jewelry, etc. & tie back long hair. Do not put fingers near moving parts!
• Metal may have sharp edges before and after cutting, handle with gloves and avoid sharp edges.
FIG. 8
FIG. 9
