Eastwood 20636, Инструкция по эксплуатации

Страница: 5 / 12

FLYING CHIPS HAZARD!
• Grinding and sanding will eject metal chips, dust, debris and sparks at high
velocity. To prevent eye injury wear approved safety glasses.
• Wear an OSHA-approved respirator when grinding or sanding.
• Read all manuals included with specifi c grinders, sanders or other power
tools used before and after the Stud Welding process. Be aware of all
power tool safety warnings.
PINCH HAZARD!
• Operating the Slide Hammer exerts considerable striking force in use,
which can quickly pinch fi ngers and hands. Grip and operate tool only
by the hand-grip areas to avoid pinching.
To order parts and supplies: 800.345.1178 >> eastwood.com
5
SET UP
To utilize your Eastwood MIG Stud Welder Kit, you will need a MIG welder with a minimum of
100 Amp output that utilizes a Tweco style nozzle.
NOTE: This was designed for Tweco-Style torches, but may work on other styles.
1. Loosen the set screws on the body
of the Eastwood Stud Welding
Nozzle and slide it over your gas
nozzle. The Pin Holder Branch of
the Eastwood Stud Welding Nozzle
should be oriented as shown in
(FIG 1).
2. Tighten the two set screws, with
the included 2mm Hex Key, once
the Stud Nozzle has been put in
place but keep in mind that it may
require adjustments when getting
started for optimum results.
SHOCK HAZARD!
All the following steps MUST be completed with the welder turned off
and uplugged.
FIG. 1 FIG. 1
Stud Weld Nozzle
Set Screws
Pin Holder Branch
Set Screw