Eastman Heavy Machinery
26
·
Wind and weather conditions
·
The presence of unauthorized personnel
·
Other possible unsafe conditions
Chapter 7 – Operating Instructions
The aerial platform may be operated from either the lower or upper controls.
Danger
The aerial platform is not electrically insulated. Death or serious injury will result from contact with,
or inadequate clearance from, an energized conductor. Do not go closer than the minimum safe
approach distance as defined by ANSI or national safety regulations.
Pinch points may exist between moving components. Death or serious injury will result from
be-coming trapped between components, buildings, structures, or other obstacles. Make sure there is
sufficient clearance around the machine before moving the chassis or platform. Allow sufficient room
and time to stop movement to avoid contact with structures or other hazards.
The aerial platform can tip over if it becomes unstable. Death or serious injury will result from a
tip-over accident. Operate the aerial platform on a firm, flat, level surface. Avoid travel speeds and/or
rough terrain that could cause sudden changes in platform position. Do not drive or position the aerial
platform for elevated use near any drop-off, hole, slope, soft or uneven ground, or other tip-over
hazards. Do not raise the platform in wind speeds above 12.5 m/s (28 mph).
The platform rated work load is the total weight of the personnel and equipment that may be lifted in the
platform. The work loads are stated on the platform rating placard mounted at the rear of the platform.
Danger
The aerial platform can tip over if it becomes unstable. Death or serious injury will result from a
tip-over accident. Do not exceed the capacity values indicated on the platform rating placard.
Capacity values indicate the rated lifting capacity and do not indicate aerial platform stability.
The operator bears ultimate responsibility for ensuring that the aerial platform is properly set up for the
particular conditions encountered.
Preparing for Operation
Make certain the batteries are charged and the charger is unplugged before operating the aerial platform. Use
the following procedure to prepare the aerial platform for operation.
1.
Perform a prestart inspection.
2.
Close and latch the battery and hydraulic trays.
3.
Place the battery disconnect switch in the on position.
Lower Controls
