Installation 13
Install Front and Rear Tables
Front and rear tables are identical and therefore interchangeable. Temporarily loosen
socket head cap screws at the locations shown in the following illustration. Align the
keyhole slots in the table flanges with the loosened cap screw heads and position the
end table so rollers are level with rollers in the case taper body, then re-tighten cap
screws to secure table. Install one table at each end (front and rear) of the case taper
body.
Next Steps
Follow instructions in the Operation section for instructions to load the tape cartridges in
the upper and lower tape heads.
If tape heads have not been loaded with tape, load the upper and lower tape heads with
tape. (One roll each; follow instructions provided in the Tape Cartridge User Guide.)
Refer to the Adjustments section for instructions to make necessary height and width
adjustments that must be made for operation of the box taper.
Refer to the Operation section for instructions to power up, operate, and shut down the
machine.
Socket Head
Cap Screws
Socket Head
Cap Screws
Содержание SB-2EX
