Eastey Perfomance EN Series, Руководство пользователя

Страница: 21 / 40

Maintenance 21
Maintenance
The Eastey EM Performance Series Semi-Automatic L-Sealer will provide many hours
of maintenance-free operation. There are a few items that may require attention from
time to time.
Daily

Clean the sealing areas: hot knives or cutting rules and silicone rubber or felt
pads.

Ensure no parts are torn or missing on upper and lower seal areas. Replace as
needed.

Check wire takeaway belt for material stuck on or in belt. Clean if necessary.

Inspect film cradle rollers. Repair or replace as needed.

Check conveyor height adjustment.

Check power cord and wiring for wear and loose connections.

Check for any loose fasteners.
Monthly

Check and adjust conveyor tension if required.

Check wire belt and replace worn links or belt if required.
Silicone Rubber and Felt Seal Pad Replacement
Occasionally it will be necessary to replace the silicone rubber or felt sealing pads. Seal
pads are designed with a channel to make them easy to install and replace. Seal pads
should be replaced if the following symptoms are observed.
•
Gaps in the seal
•
Weak seals
•
Improper film cutoff
•
Excessive sealing pressure required
To replace a silicone rubber or felt pad, pull the old pad out of the channel and replace
with the new silicone rubber or felt pad, pressing it into place in the channel.
NOTE: Some silicone rubber pads come covered in talcum powder. If so,
clean the pads with a mild solvent.