Eastey EPerfomance M1636T, Руководство пользователя

Страница: 28 / 40

28 Maintenance
Step 5 – Check Entire Belt Circuit
•
Z-bends should not come into contact with any conveyor component (including
end rolls, wear strips, transfer support rails, nose bars, etc.)
•
Adjust as needed.
Step 6 – Adjust Tension
•
The wire belt used is a low-tension belt. Use minimal tension — only enough so
the sprockets properly engage the belt.
•
Run the conveyor and check to make sure it runs smoothly.
Note: Too much tension will cause premature belt failure.
Film Roll Support Rollers
Make sure rollers stay clean and grease free. If you should have to clean the rollers,
simply wipe them down with a clean lint free cloth. If a more thorough cleaning is
necessary wipe the rollers down with a mild detergent and water and let dry.
Never use
harsh or abrasive cleaners or chemical agents when cleaning the rollers.