Troubleshooting 31
Troubleshooting
Problem
Solution
Taper will not start
•
Check power input.
•
Release the Emergency Stop button.
•
Release overload.
•
Replace Fuse.
Machine is not operating
•
Machine has inadequate electrical power or
power is not connected. Verify system power
meets specification requirements.
•
An Emergency Stop condition exists. Clear the
machine and reset the Emergency Stop.
Stuck carton
•
Check drive belt width adjustment.
•
Check for proper height adjustment.
Uneven or poor tape cuts
•
Adjust knife arm spring tension.
•
Adjust wipe roller spring tension.
•
Replace cutting knives.
Uneven Tape Leg on Front
•
Tape tension is too low. Tighten the one-way
clutch roller and/or the tape core.
•
Adjust the one-way clutch roller in the slot so it
is slightly beyond the front wipe roller.
•
Adjust the tape leg length. See Tape Leg
Adjustment section.
Содержание BB-2
