Some products may not be available in your country, please contact our distributor for more details
Some products may not be available in your country, please contact our distributor for more details
6.OSD - Zones and Privacy Mask
17
Zones
You can define the zones in the whole PT range up to
8 zones. When the display setting “Zone Label” is
activated, its label will be displayed on the screen.
The defined ranges of the zones should not be
overlapping.
Supports up to 8 zones.
Left boarder of the current zone.
Right boarder of the current zone.
Delet the current zone.
Changes the label (name) of the
current zone.
ZONE NUMBER:
SET LEFT LIMIT:
SET RIGHT LIMIT:
CLEAR ZONE:
EDIT ZONE LABEL :
ZONES
ZONE NUMBER
1
SET LEFT LIMIT
SET RIGHT LIMIT
CLEAR ZONE
EDIT ZONE LABEL
BACK
EXIT
Privacy Mask (Window Blanking)
Privacy Mask is used to protect the privacy area that
should not be displayed once the camera is pointed
on it, such as lavatory areas or the operation desk of
an ATM machine. This might be mandatory required
by local law regulations. The Speed Dome supports
up to 24 private masks (depending on the installed
camera module; please contact your local sales
representative for more information).
Hitachi camera modules
Sony Camera modules:
LG,CNB Camera modules:
: 8 masking areas
up to 24 masking areas
(except the 45 series provides only 8)
no masking function
Mask number.
Edit position of the mask using the
keyboard’s joystick. Presse IRIS-OPEN to save.
Shows the mask on the screen.
Deletes the mask.
WINDOW NUMBER:
EDIT WINDOW:
ENABLE WINDOW:
CLEAR WINDOW:
WINDOW BLANKING
WINDOW NUMBER
01
EDIT WINDOW
ENABLE WINDOW
OFF
CLEAR WINDOW
BACK
EXIT
7.PROTOCOL SETTING
Protocol Setting
This procedure is needed if a connection of the
telemetric control with the keyboard device is
desired. You need to setup the dome address and
protocol settings.
The speed dome support multiple communication
protocols. The settings can be changed by
rearranging the DIP-Switches on the rear side of
the connector board as illustrated.
Please use the following table for detailed
information.
Baud rate
DIP 7
DIP8
2400 bps
0
0
4800 bps
1
0
9600 bps
0
1
19200 bps
1
1
SW 1:
Represents the dome’s address in binary form.
Please refer to the list on the next pages for
reference.
Used for protocol settting and baud rate.
SW 2:
DIP 1 to 6 : Protocol settings
DIP 7 and 8:Baud rate settings
B02
0 0 1 1 0 0
DIAMOND
1 0 0 1 0 0
HUNDA
1 0 1 1 0 0
KALATEL
0 1 0 1 0 0
LILIN
1 1 0 1 0 0
MOLYNX
0 0 1 0 0 0
PANASONIC
1 1 1 0 0 0
PELCO (D/P)
1 0 0 0 0 0
PHILIPS
0 0 0 0 0 1
SAE
0 1 0 0 0 0
SAMSUNG
0 0 0 1 0 0
SANTACHI
0 1 1 0 0 0
UNIVISION
0 1 0 0 0 1
VCL
1 1 0 0 0 0
VICON
1 0 1 0 0 0
AD
0 0 1 1 0 0
Protocol / DIP
1 2 3 4 5 6
