Figure 2.6.5 file list results save interface
File naming interface operation instructions
:
1.The file can be edited by switching the
direction key to the editing state, and then the file can be saved by pressing the [Enter] key, and an
error will be reported if it is empty. 2. The character is selected by a rotary knob and the character
is typed by pressing the [Enter] key. 3. Press [Esc] to return to the upper interface.
Figure 2.6.7 named naming interface
2.7 Scan test operation
Scanning test can be used to detect the continuous operation of the source to be measured in a
certain range, and can easily capture the critical parameters of the source to be measured, such as p
rotection current, turning voltage and so on. Users can set parameters such as starting point, end p
oint, step quantity, step delay, threshold type, comparison type and so on. The end of the scan test
shows that the test results are qualified or not.
Parameter setting interface operation instructions
:
1.Press the [Shift]+ [
◀
] (Menu) key to enter the scanning settings interface under the scanning test main interface; 2.
Select the operation item by rotating the knob; 3. Switch the settings options by pressing the
[Enter] key for non-numeric parameters; 4. For numeric parameters, press the [Enter] key to enter
the editing mode, select the corresponding digits through the direction key, and then rotate the
spin. Button adjustment value, [Enter] or [Esc] key out of editing; 5. return to the next level by
[Esc].
Test interface operation instructions
:
1.Press [On/Off] to start or close mode.
15