Page: 16
p
56. Locate the control horns.
p
57. Carefully push the horns pegs through
the surface. Keep the leading edge of the
horns base aligned to the trailing edge of
the surfaces bevel.
p
58. Clean out any foam that may be pushed
out of the holes.
p
59. Add a bit of glue to each side and
press on the retainer clip.
p
60. Note the horns location, compared to
the travel of the elevator.
p
61. Horn placement is best in an area that
will prevent horns and linkages from
interfering with the travel of the surface.
