Easson EX-100, Руководство пользователя

Страница: 10 / 33

9
25. Back locking nut for the measuring spindle
26. Locking hand-wheel for Abbe measuring device
27. Locking screw for the gate of balance weight adjustment
28.29 adjusting screw of the fixing shaft for measuring cap-shaped accessories on the tail
stock
30. Locking hand-wheel for tailstock 31. Siding carriage on the tailstock
32. tailstock spindle
The universal worktable (2) is a basic worktable. We can put various auxiliary
worktables on it. During installation, insulating worktable, center carrier, tilting
worktable or round floating worktable can be fixed on it by using a tilted surface in
the two sides of the universal worktable. There are two T-shaped slots in the universal
worktable to fix a pressing board, single V-shaped rack, double V-shaped rack or a
cross-shaped rack. According to the requirements, the universal worktable may carry
out the following motions:
a) The universal worktable can be adjusted within 100 mm in vertical direction by
using the hand wheel (6) and scales (10) or to be preset a limited position and locked
by the button (7).
b) The universal worktable can move within 25 mm in Y-direction by turning the
hand-wheel (15) with scales of 0.01mm.
c) The universal worktable can deflect 3 around Y-axis by adjusting the operating
rod (11). Then lock the worktable in a desired position with the locking rod (13).
d) The surface of the universal worktable may rotate 4 around the vertical axis by
turning the handwheel (14).
e) The X-direction of the universal worktable surface moves on the spherical guide
with a stroke of 18mm to make the workpiece to be measured positioning freely
without any restriction.