EAS Electric EMH46RN, Инструкция по эксплуатации

Страница: 31 / 74

Connection to the gas supply
The gas Connection must be made in
accordance with the local standards. When
installing, fit a safety tap at the end of the
pipeline. The appliance leaves the factory
tested and set for the type of gas indicated
on the plate inside the bottom guard, close
to the gas connection pipe. Make sure that
the type of gas to be supplied to the
appliance is the same as that shown on the
plate. Otherwise, follow the instructions
provided in the " Adapting to different types of
gas " section.
For maximum efficiency and minimum
consumption, make sure that the gas supply
pressure complies with the values shown in
the gas used is different from that specified
(or variable). A suitable pressure regulator
must be installed on the supply pipeline.
The union must be fitted on the end of the gas train. Complete
with GJ1/2'' threaded nut, fitting the gasket between the
components as shown in the illustration. The gaskets must
comply with the local standards. Screw the parts together
without forcing, fit the union so that it points in the direction
required then tighten all parts.
Connection
Make the connection to the gas system using a rigid metal pipe
and regulation unions, or with a stainless steel hose complying
with the local standard. If metal hoses are used, take care that
they do not come into contact with mobile parts and are not
crushed. This must also be checked if the hob is to be combined
with an oven.
The gas intake connection of the appliance has a “ male thread.”
When making the connection, take care not to apply stresses
of any kind to the appliance.
When the installation is complete, always check that all
the unions are absolutely tight using a soapy solution.
Never use a flame to make this check.
V.1 13