EAS Electric ECMV2 Series, Инструкция для владельца и по установке, Страница: 88 / 276

2. Remove foam stops from inside
the fan.
3. Attach the side of the front grille to
the panel.
4. Connect the display panel cable to
the corresponding wire on the
main body.
5. Close the front grille.
6. Fasten the installation covers at all
four corners by pushing them
inwards.
NOTE: If the height of the indoor
unit needs to be adjusted, you can
do so through the openings at the
panel’s four corners. Make sure that
the internal wiring and drainpipe
are not affected by this adjustment.
Water condensation
CAUTION
Failure to tighten screws can cause
water leakage.
Loosen upper nut
Adjust lower nut
Gap not allowed
CAUTION
If the unit is not hung correctly and a
gap exists, the unit’s height must be
adjusted to ensure proper function.
The unit’s height can be adjusted by
loosening the upper nut, and adjus-
ting the lower nut.
Compact models
Step 1: Remove the front grille.
1. Push both of the tabs towards the
middle simultaneously to unlock the
hook on the grille.
Grille hook
2. Hold the grille at a 45° angle, lift it
up slightly and detach it from the
main body.
Step 2: Install the panel
Align the indicate "△" on the decoration
panel to the indicate "△" on the unit .
Attach the decoration panel to the unit
with the supplied screws as shown in
figure below.
After installing the decoration panel,
ensure that there is no space
between the unit body and decora-
tion panel. Otherwise air may leak
through the gap and cause dewdrop.
(See figure below)
Screws (M5)
(supplied with
the panel)
Decoration
panel
42 V. 2