ASSEMBLY
CUTTING HEIGHT ADJUSTMENT
See Figure 8
When shipped, the wheels on the mower are set to a low-cutting
position. Before using the mower for the first time, raise the
cutting position to the height best suited for your lawn. The
average lawn should be between 1-1/2 in. to 2 in. during cool
months and 2 in. or higher during hot months.
To adjust the cutting height:
Remove
switch
key
and
battery
pack.
To raise or lower the cutting height, loosen the height
adjustment lock
knob (A) on the left side and then pull out
the height adjustment knob (B) on the right side. Move it up
and down to best suit your need. Once
the
best
height
is
achieved, release the
knob
on
the
right
and
re-tighten
the
lock knob
on
the
left. C is the highest blade setting.
INSTALLING THE GRASS CATCHER
(For Rear Bagging Operation)
See figure 6-7
Remove
switch
key
and
battery
pack.
Lift the rear flap (A).
There
are
two
sections
of
formed
plastic
grooves
at
the
front
underside
of
the
catcher
.
Snap
the
formed
section
over
the
support
tube, between the trailing
wheels of the mower.
Adjust the strap (B) to its appropriate length and then
attach hook to handle to suit your height and technique.
Release the rear flap.
Reinstall
switch
key
and
battery
pack when you are
ready to mow.
9
Model 2120-16
INSTALLING/REMOVING BATTERY PACK
See figure 9-10
To Install Battery Pack
Lift and hold up the battery cover (1).
Align the battery (2) with the mower’s battery port.
Make sure the battery release button (3) snaps in
place and that battery is fully seated and secure in
the mower before beginning operation.
If the machine is not going to be used immediately,
remove the battery.
To Remove Battery Pack
Release the bail wire to stop the mower.
Open the battery cover. Press the battery release
button (3) on the battery.
Remove battery from the mower.
A
Fig. 6
Fig. 7
B
A
B
C
Fig. 8
Fig. 9
1
2
3
3
Reinstall
switch
key
and
battery
pack when you are
ready to mow.
Fig. 10