7.
Slide axle bushing over axle and into axle
bearing to both sides as shown.
8.
Install drive wheel to axle using pin hole nearest to lower handles as shown. Insert 2” cot-
ter pin through wheel and through axle. Bend with pliers to prevent pin from falling out.
TURN SPREADER UPRIGHT ON TO WHEEL.
10.
Insert pivot rod into shut off plate as shown.
(T
IP
: Make
sure the double bend end of the Pivot Rod is facing the Shut-off
plate)
to the Turn to lock in place.
11.
Insert other end of pivot rod into pivot and bracket
assembly as shown. Turn to lock in place.
12.
Install control support between lower handles as shown
above inserting (2) 1 3/4” bolts thru Pivot Bracket and Lower
Handle, Control Support an other Lower Handle and secure with
1/4-20 lock nuts . Line up hole in cross brace with hole in control
support. Insert 1/4-20 x 2 1/4” bolt through control support and
through hole in cross brace. Apply 1/4-20 locknut.
DO NOT
TIGHTEN LOCKNUT YET. TIGHTEN THIS NUT LAST
.
PAGE 3
9.
Install coast wheel to axle using outside pin hole. As shown, insert 1”
cotter pin through axle (not thru the wheel). Bend with pliers to prevent
pin from falling out.
