4.
Install gear box by inserting the pinion shaft into hole in
center of hoppers bottom. The word
“FRONT”
on the gearbox
must point toward the
hitch
.
Follow label instructions on the hopper.
5.
Install axle bearings to both lower handles.
NOTE:
Notch on bearings and lower handles.
Bearings must go through flat side of lower handle.
3.
Install impeller onto pinion shaft. Insert
⅛
”x 1-1/4” cotter pin
through impeller then through pinion shaft. Use hole closest to the
gear box. Spread cotter pin to prevent from falling out. Next insert
cross brace (
smaller diameter without the cross hole
) thru the Gearbox
Brace.
NOW GO BACK AND TIGHTEN ALL NUTS AND BOLTS STARTING WITH FIRST STEP. DO NOT OVER TIGHTEN.
PAGE 2
6.
Install lower handles onto axle to both sides as shown. Insert 2 ¼” bolt through second hole in lower handle and through first hole in
frame install locknut.
DO NOT TIGHTEN.
Now insert 1 ½” bolt through first hole in lower handle. Then through frame brace.
NOTE:
Dimples on frame brace must be facing toward gear box as shown. Next into threaded connector in cross brace (
smaller diameter without
the cross hole
).
DO NOT TIGHTEN.
Next insert 1 ½” bolt through other end of frame brace and through second hole in frame threaded connector in cross brace.
