CARE & SAFETY INSTRUCTIONS
>
Occasionally clean the speaker stand with damp cloth or
non-abrasive cleaner.
>
Install the speaker ONLY when the stand/tripod is in a fully
upright position with all legs on the floor.
>
Do not lubricate or use silicone spray on the center tube.
>
Do not drag the speaker stand/tripod while it is loaded as
this may cause damage to the fittings and the stand itself.
>
Before placing the speaker, make sure that the telescoping
collar is securely tightened and the safety pin is fully
inserted into the slot on the upper telescoping tube.
>
Always practice caution when releasing the collar and stand
clear of speaker.
SPECIFICATIONS
Height Adjustment
Load Capacity
Upper Tubing Diameter
Material
43 5/8” - 73 5/8”
1100 - 1870mm
132 lbs. 4 oz.
60kgs
1 3/8”
35mm
Aluminum tubing with
Plastic collars
SETUP INSTRUCTIONS
STEP 1
Loosen leg fitting hand knob.
STEP 2
Spread the tripod legs to maximum
diameter of leg spread then retighten
the leg fitting hand knob.
STEP 3
Remove safety pin from upper
telescoping tube slot. Loosen hand
knob on telescoping collar and raise
center tube about 6 to 10 inches.
Retighten the hand knob.
STEP 4
Put speaker cabinet on top. Slowly
loosen the hand knob and raise the
cabinet to desired height. Tighten the
hand knob and insert the safety pin
into the slot on the telescoping tube.
STEP 5
To remove the speaker, remove the
safety pin from the slot. Slowly loose
the hand knob. Carefully and slowly
lower the upper telescoping tube.
Tighten the hand knob before
removing the speaker from stand.
CAUTION:
DO NOT
over tighten the hand knob.
DO NOT
store in tightly locked
position.
specifications are subject to change without notice
www.earthquakesound.com
