EarthQuake 7050, Руководство оператора

Страница: 15 / 36

15
ARDISAM
OPERATION
SHUTTING DOWN
TILLING
1. Adjust the depth regulator lever to desired tilling
depth.
NOTE: Raise depth regulator lever up one hole at a
time, testing tiller operation after each raise. Raising
depth regulator lever too high can result in loss of
control of tiller!
2. Move the throttle control to fast .
3. Place the tiller in forward by pushing down on the
drive safety control levers--this will engage the
wheels and tines.
NOTE: You can slow the tiller's forward advance at
any time by putting slight downward pressure on
the handlebars, or you can stop the tiller by
releasing the drive safety control levers to the
neutral position.
To stop wheels and tines at any time, release drive
safety control levers to neutral position.
Always release drive safety control levers to neutral
position before adjusting the depth regulator lever.
Practice operating the controls and tiller with tines
out of ground before beginning to till. It is important
that you know how to use the tiller properly, how
to keep control at all times, how to stop the tines
and wheels from turning, and how to stop the
engine if necessary. If you do not know how to do
these things, read the Controls, Adjustments and
Safety sections before proceeding.
Temperature of muffler and near by areas may
exceed 150
°
F. Avoid these areas.
Do not move choke control to CHOKE to stop
engine. Backfire or engine damage may occur.
To stop the engine at any time, move throttle
control to the off position. To stop wheels and tines
at any time, release drive safety control levers to
neutral position.
WARNING
WARNING
Engine and surrounding parts become extremely
hot during normal use, and will cause serious burn
injuries if touched before the engine has cooled.
Allow engine to cool completely before touching
these hot surfaces.
DANGER
WARNING
WARNING
WARNING