Earlex SteamStation SC300, Руководство пользователя

Страница: 6 / 12

6
Cleaning Floors
RED
LIGHT
ON/OFF
SWITCH
ORANGE
LIGHT
Note: If you stop working for a while a small amount of water may accumulate in the steam hose
after use. This is due to the steam cooling in the hose. When you switch the unit back on a short
jet of water may eject from the end of the hose after the steam trigger is pressed. Drain this water
by pressing the steam gun into a cloth (careful it may be hot) before starting your task.
Refilling the water tank
• Switch the SteamStation off using the on/off
button.
• Unplug the SteamStation from the electrical
socket-outlet. Wait 5 minutes before
squeezing the safety trigger to make sure it
is no longer under pressure before
unscrewing the safety cap. DO NOT unscrew
the Steam Cap (6) until the steam has
> stopped.
• Fill the water tank as necessary using the
Funnel (3) provided. DO NOT exceed 1.25
> quarts (1200ml) of water before replacing the
> Steam Cap (6) by turning clockwise. Fasten
> cap tightly.
• You are now ready to switch the
SteamStation on and resume steam cleaning.
3
2
MAX 1200ml
Instructions for Use
• Make sure the SteamStation is unplugged
from the electrical socket-outlet.
• Unscrew the Steam Cap (6) by turning
anticlockwise.
Please note the Steam Cap (6) cannot be
> unscrewed when the unit is pressurized.
• Using the measuring Jug (2) and Funnel (3)
> fill the SteamStation up to 1200ml or two
> complete fills of Jug (2) of water. This should
> be sufficient to steam clean for approximately
> 30 minutes.
• Once full, replace the Steam Cap (6) by
> turning clockwise and fasten tightly.
• Attach the accessory or floor cleaning tool
you require to the SteamStation (see page 7
> & 8).
• Now plug the SteamStation into the electrical
socket-outlet and switch on. Two lights should
illuminate. The red light is a power indicator.
The orange light indicates that the
> SteamStation is building steam pressure.
When the SteamStation is first turned on this
light will illuminate. The SteamStation takes
up to 7-8 minutes to reach the correct
pressure level depending on the amount of
water in the tank.
• Once the orange light has gone out the
SteamStation is ready to use. The orange
light may come back on when the
SteamStation is in use. If this happens,
release the safety trigger and allow the steam
pressure to build up once again. This should
take no longer than 40 seconds. If the safety
trigger is pressed when the orange light is on,
hot water may leak out from the
SteamStation.