Earlex SPRAYSTATION GEMINI, Руководство по эксплуатации

Страница: 9 / 20

9
Priming – Direct from the paint tin (or Gemini Bucket)
1) If the spray gun is not in the docking station, scroll the Paint Flow Adjuster (8) on the back of the
gun up to maximum – then place the gun in the docking station (Fig.11).
2) Remove the head unit and place the Paint Pot (12) filled with water into the Gemini Bucket
>>> (25) and re-fit the head unit making sure the Pick-Up Tube & Filter Cage (18b & 18c) is fully
>>> immersed in the water (Fig.12).
3) Plug the unit in, set paint speed dial on the unit to setting 5 (Fig.12), and turn the pump on (Fig.12).
4) When water starts coming out of the front of the gun (you will see this in the docking station while
it is on) - turn the pump off remove the paint pot and gun from the docking station
- switch the pump on and expel the remaining water through the gun into the paint pot.
Tip: If the water does not reach the end of the gun, make sure the paint flow adjuster is scrolled up
>>>> to maximum and the gun trigger is depressed fully in the docking station.
5) Remove the Paint Pot (12) from the Gemini Bucket (25) and replace it with the paint mixed
and thinned (if necessary) making sure the Pick-Up Tube & Filter Cage (18b & 18c) drop into the
>>> paint (paint can either be poured directly into the Gemini Bucket (25) or preferably you tin use
the paint can that it comes in).
6) Ensure the paint tin is placed under the spray gun – use the rings on the base of the Gemini
>>> Bucket (25) as a guide.
NOTE : Make sure the spray gun is firmly placed in the docking station with the trigger depressed.
7) Turn pump on (Fig.12).
8) When the paint starts to comes through the tip of the gun your unit is primed (this should take up
to 2min). Turn pump off.
9) Uncoil the black Air Hose (15) from around the Gemini Bucket (25), and fit to the head unit
and gun using a TWIST motion.
10) Join the 4m Paint Tube (13) and black Air Hose (15) using the clips supplied. Do this at 1m
>>> intervals, using a tweezer action on the clip, connect the Paint Tube (13) first. A good tip is that
>>> the first clip should be placed 0.5m from the head of the unit. It is also easier to do this with the
>>> gun out of the docking station.
Your Gemini is now ready to spray!
SOLVENT-BASED COATINGS CANNOT BE USED WHEN SPRAYING DIRECT FROM THE TIN.
ALWAYS PRIME THE UNIT WITH WATER BEFORE STARTING ANY JOB. ENSURE YOUR PAINT IS AT ROOM
TEMPERATURE. ALWAYS DILUTE USING WARM WATER.
Fig.11
Fig.12
Fig.13
Fig.14
DVD