11) TROUBLESHOOTING
PROBLEM
CAUSE
ACTION REQUIRED
The paint drips onto the item being painted
Paint too diluted
Add undiluted paint
Paint output too high
Reduce the paint output by adjusting the screw
(8)
Moving too slowly
Increase speed of application
Gun trigger held for too long
Release trigger sooner
Gun too close
Increase the distance between the gun and the
work surface
Paint is too thin or irregular
Paint too diluted
Add undiluted paint
Paint output too low
Increase the paint output by adjusting the screw
(8)
Moving too fast
Reduce speed of application
Gun clogged
Clean the gun
Gun too far away
Move the gun closer to the work surface
No paint being released
Paint too thick
Add thinner
Fluid tip clogged
Clean the fluid tip
Feed tube clogged
Clean feed tube
Air hose split
Replace air hose
Grainy paint
Filter the paint
Container almost empty
Refill container
Gun at an angle
Check that the feed tube is pointing towards the
paint (11)
Air inlet blocked
Check the condition of the filter and clean if nec-
essary (16)
Paint leaking from the gland nut (9) in front of
the trigger
Gland seal(10) not attached or the wrong way
round or not tight enough.
Reattach the gland seal (10) and retighten gland
nut.
Over time the gland seal (10) will wear and need
adjusting
To check the gland nut is correctly fitted you will
need a small adjustable spanner. Pull the trigger
(17) back and gradually tighten the gland but by
turning it in a clockwise direction until the needle
is not free to move when the trigger is released.
8
Содержание HV4900
Страница 1: ...SPRAY STATION HV4900...