User manual
E&P HYDRAULICS
4. Users advices (tips)
4.1 Antenna
The main-unit (operating system) and the antenna are build in together with the hydraulic
pump in a plastic casing (pumphousing).
At older systems (before 2013) it is likely that the main unit (operating system) is of an older
type. To make it possible using the remote control, this older main unit should be replaced by
the newest version.
In addition, the cover of the pumphousing also need to be adjusted, in order to make it
possible mounting the antenna. (see below)
When a caravan level system is mounted/delivered without the use of a remote control, than
on the cover of the pumphousing a label with an antenna signal is present. This label covers
the hole in the cover due to the absence of the antenna.
4.3 Which device takes command
The device which is operated first (remote control or control panel) takes the command to
control the system, until that device is switched off.
If you would like to switch from one control device to another,
you need to switch off the
power from the device that was in operation first.
In the event of switching off the remote control, you have to wait a little time, to give the
system enough time to switch off contact between the remote control and the main unit.
4.4. Low Battery level indicator
When the battery level indicator LED (16) lights RED, the device does not stop working
immediately. After this signal it is possible to use the remote control another 4 times.
Make sure there is a spare battery in the caravan.
9.
Situation (old) : before 2013
Pumhousing view at a main unit
without antenna connection
Situation (new) : after 2013
Pumhousing view at a main unit
with antenna connection
