User manual
E&P HYDRAULICS
2.2 Remote control programming
Step 1.
In order to pair the remote control to the system, remove the fuse (30Amp.)
out of the cable assembly from the hydraulic levelsystem or disconnect the
de 9 pins cable connector from the main unit. (
do this by gently pressing the
two hooks on the side of the connector)
Step 2.
Press the Butto
ns “
deploy jacks automatically
” (no. 7) and
“
retract all jacks
” (no. 8)
simultaneously
for at least 1 second.
When done the Indicator LED (no. 14) with the surrounding
4 arrows starts blinking GREEN / ORANGE nervously.
This means the remote control is looking for its receiver
(mounted within the main unit).
Step 3.
Depending on what action you performed under step1, reconnect the
9 pin connector or fuse to the system.
Extra Note!
The pairing process should be made within a certain time (apr. 20 sec.)
-
The remote control turns off automatically.
-
When the Iindicator LED goes off the pairing process is guaranteed.
Step 4.
Turn the remote control ON by pressing button
“
on/off
” (no. 5) for at least
1 second.
Now the GREEN LED between the four arrows in the middle will light up by
flashing. As long as you see this LED flashing, the Remote control is
searching for contact with the Main unit. When contact is made, the flashing
stops.
By means of illumination of one or two ORANGE arrows the remote control
shows in which way your vehicle is leaning. Or the GREEN LED
This could be 8 + 1 = 9 possibilities.
+
Using the Remote control:
After programming your remote control, you now have two options to level your caravan:
operating your system by the remote control or the (built in) control panel.
The operation is described in the E&P Hydraulics User
’s Guide of the caravan.
7.
