The material contained in this document is the property of Electronics & Innovation Ltd., it is
subject to change without notice.
August 2012
Revision B
6
In the event of a fault, the unit may be reset by cycling the power. In the case of
an over temp fault, ensure that the air inlet and out let are not restricted. If the
fault persists, please contact Field Service.
2.3.3 RS 232 Interface
The 2400L features a standard RS-232 serial interface suitable for connection to
a PC or host system. The communication protocol is extremely simple to
facilitate readback and control with readily available terminal programs such as
Hyperterm. The RS-232 link has the following parameters:
Baud rate:
19200
Data bits:
8
Parity:
none
Stop bits:
1
Flow control: none
An example configuration using HyperTerminal on a PC is shown in figure 2.2.
In the default state, the RS-232 port will echo the same information sent to the
front panel LCD display, allowing a running datalog to be stored to disk using the
capture feature of the terminal program.
Figure 2.2: Example RS-232 setup using Hyper Terminal