The material contained in this document is the property of Electronics & Innovation Ltd., it is
subject to change without notice.
January 2006
4
Revision B
Table 1-1. SPECIFICATIONS
FREQUENCY COVERAGE:
10 kHz to 12 MHz.
GAIN:
53 dB min, ± 2.0 variation.
CLASS A LINEAR OUTPUT:
Nominal 200 watts.
HARMONIC DISTORTION:
> -25 dBc at 200 watts output.
SATURATED RF POWER OUTPUT:
350W Min.
from 30kHz - 4MHz;
250W Min.
from 10kHz - 10MHz;
225W Min.
from 10MHz - 12MHz.
INPUT IMPEDANCE
50 ohms, VSWR, 1.5:1 Maximum.
OUTPUT IMPEDANCE:
50 ohms, VSWR, 2.5:1 Maximum
STs STABILITY:
Continuous operation into any load or
source impedance.
PROTECTION:
Unit will withstand a + 13dBm input
signal (1.0 Volts RMS) for all output load
conditions, without damage.
POWER OUTPUT METER:
True RMS power detection. ±3% of full
scale accuracy.
POWER REQUIREMENTS:
85 – 264 VAC 47-63 Hz.
SIZE:
5 1/4 X 16.5 X 18.1inches 13.4 X 41.9 x
46.0 cm.
WEIGHT:
52.5 pounds 23.8 kg
CONNECTORS:
BNC
OPERATING TEMPERATURE:
0 – 40 C
RACK MOUNTING:
Chapter 2 Operation
2.1 INTRODUCTION
The 2200L RF amplifier is used to amplify the RF level of signal sources in the 10
KHz to 12 MHz range. No tuning or any other form of adjustment is required.
The 2200L produces rated power output at its output connector, into most loads,
regardless of load impedance. Any power reflected due to output load mismatch
is absorbed in the amplifier. Therefore, although the output impedance is 50
ohms (maximum VSWR: 2.5:1), the amplifier will work into any load impedance.
At some phase angles into grossly mismatched loads the maximum power
available may fall to 80% of rated power.
