5
Unpacking:
Carefully remove from the box your
amplifier and keep the original
carton and packing materials for
future trips, expeditions or long-term
storage
Before the installation :
remove your amplifier, taking care to
keep it in the future if you ever
require to be shipped to a service
center EAMLAB to be overhauled or
repaired.
package contents:
Verify that the following acessories
are included in the package:
remote control, power cord and this
manual.
Replacing Batteries
If the remote control only works
when it is near the unit, the
batteries are weak. Replace the
batteries with new ones.
Note
For replacement use only
batteries model CR3020.
Make sure the polarity is
correct
For
change
battery
remove 4 screw in bottom
side
and
leave
the
electronic board . battery
are bottom of printed
circuit
Use remote control
The remote control transmits a
directional infrared beam. During
operation, be sure to point the
remote directly at the infrared
sensor.
When the sensor is covered or there
is a large object between the remote
control and the sensor, the sensor is
not receiving the signals. The sensor
may not be able to receive signals
properly when it is exposed to direct
sunlight or strong artificial light (such
as a fluorescent light or a flashing).
In this case, change the direction of
light or reposition the unit to avoid
direct lighting.
Note
• Handle the remote control
carefully.
• Do not spill water or other liquids
on the remote control.
• Do not drop the remote control.
• Do not leave or put away the
remote control in the following
conditions: - High humidity or
temperature such as near a heater, a
stove or a bathroom; _ Dusty; -
Expose to temperatures very low or
very high