Low Med High Low Med High
Strobe (I/II) S.O.S.(I/II) Beacon
Low-Flash (cycle)
1) Unscrew the tailcap and insert
new batteries with positive termi-
nals facing the front. Replace tailcap
and tighten snugly.
Thank you for purchasing EagleTac
D25 clicky series LED flashlight.
D25LC2 includes a battery
magazine to prevent CR123A
battery rattling.
Basic Operation
1) Press on the switch button until it
clicks to turn on the flashlight. To
switch off the light,
press the switch
again until it clicks.
2) With the flashlight on, tight the
head to access group 2 output.
Loose the head to access group 1
output.
3) Switching between modes
With the flashlight on, slightly press
the switch and release (within 1.5s)
to switch to the next output.
(D25A2/D25C2/D25LC2) Reverse the
body to change the clip orientation.
Fasten the pocket clip holding ring
(see arrow above) securely, to ensure
proper functionality.
Maintenance
Periodically clean the threads and
o-rings with a lint free cloth and apply
a thin coating of EagleTac synthetic
grease to the o-rings and threads
shown below.
After prolonged exposure to moisture,
the head and batteries should be
removed, inspected, and dried.
Do not touch or attempt to clean the
reflector, as it will damage the reflec-
tive coating permanently.
D25C2/D25LC2/D25A2
D25A/D25C
Turbo Strobe (cycle)
Group 2 (w/ head tighten):
Group 1 (w/ head loosen):
Group 2
Group 1
A2
D25 Clicky Series Quick Start
The EagleTac turbo boost technol-
ogy is activated everytime you turn
on at turbo output setting. It offers
20% more power to the LED for the
first 90 seconds. It’s normal for the
light to get warm at this level.
Programmable Features
1) Moonlight output - dim or
increase the entire output range
of the group 1 output. Toggle this
setting starting with head loosen,
turn on the light, and then repeat
tight and loose for three times.
2) mode memory* - remebers the
last output in group 1. To toggle
this setting, with head tighten,
turn on the light, and repeat loose
and tight for three times.
* This feature does not apply for D25A clicky model
Carrying Method
Use the stainless steel pocket clip
to hold the light securely at your
pocket. Use our optional M1.5 hex
key to remove the screws that hold
the clip. Our hex key is custom
made to prevent screw stripping.
Attach the stainless steel split ring
to the back of the light to use with
the para-cord lanyard.
