Eagle Heated Drawers, Руководство по эксплуатации и инструкции

Страница: 7 / 8

7
care and Maintenance
To avoid injury, turn the power off and allow unit to cool before cleaning or performing maintenance.
On freestanding units, unplug the electrical cord and/or turn off circuit breaker.
To preserve the finish of the drawer warmer, it is recommended that the surface be wiped daily with a damp
cloth. Food pans should be removed and washed. Stubborn stains may be removed with a non-abrasive
cleaner. Hard to reach areas should be cleaned with a small brush and mild soap.
Removing Lime and Mineral Deposits
Note: If the water used has an excessive amount of lime or mineral content, use the following instructions
for periodic cleaning and de-liming of the water pan.
1. Turn off the power. On freestanding units, unplug the cord from the power source.
2. After the unit has cooled down, remove the water pan.
3. Fill the water pan with a mixture of water and de-limer. Allow the pan to stand with the mixture for the
recommended period of time. The time required will depend on the solution used and the amount of
deposits in the pan. Check de-limer manufacturer for specific directions.
4. After the de-liming period, drain the solution from the pan.
5. Continue to fill and rinse the pan with water only, until the pan becomes clean.
6. Install the pan into the unit. On freestanding units, plug the power cord into the receptacle and fill the pan
as usual.
caUtion!
Abrasive cleaners could scratch the finish of the drawer warmer.