7)
The maximum achievable curve is 75mm. A
curve of less than 75mm may stress the PVC
sheath lead to product damage and Electrical
failure.
8)
The product should NOT be mounted using staples, nails or metal fixings
which can cause damage to the plastic sheath. Cable ties can be used but
must not be over tightened.
9)
Only the connectors supplied are suitable for this product. Further
accessories are available on request. The use of alternative connectors may
lead to poor electrical contact and product damage/failure. A list of these
appears on the foot of this document.
10)
The maximum single length that can be run from one power supply is 90m.
11)
The LED rope is polarity sensitive and
will only work one way so if the product
does not illuminate switch the contacts
the other way by reversing the
connection. To do this remove the
power lead and rotate 180 Degrees and
re-connect.
Maintenance
Periodically check the product for LED failure and general damage. If any of the LED’s
have failed or the product is damaged in anyway switch off and disconnect from the
mains supply.
To clean the product, switch off and disconnect from the mains supply. Using a
slightly damp cloth gently wipe over. Do not use bleach,
solvent based cleaners or strong detergents. These may
damage the product and invalidate the warranty.
If the mains lead is damaged, it must be replaced by the
manufacturer or and authorised service centre.
If the mains plug needs to be replaced, proceed as follows:
•
Connect the brown wire to the terminal labelled "L".
•
Connect the blue wire to the terminal labelled "N".
•
Make sure that the cord-grip is positioned correctly (over the
outer sheath of the cable) and it fully tightened.
•
If the plug is fitted with a 13 A or 5 A fuse, replace it by a 3 A fuse.