Operation and Installation Guide
1)
The rope light can be cut every 1m at the point marked on the rope light by
a pair of scissors or broken line.
2)
The cut must be made by a sharp knife and at right angles to the rope.
Incorrect cutting of the product can cause the final join to suffer from poor
electrical connection which can lead to product failure.
3)
The product can be reconnected in various ways by using the connectors
provided.
1.
In-Line Coupler
2.
Mains Connector
3.
End Cap
4)
All connections MUST be sealed with the heat shrink provided to make a
permanent join. Failure to use the heat shrink may result in the ingress of
water and/or the breaking of electrical connection leading to the possibility
of electrical shock/product damage.
5)
The rope is suitable for use outside but if any connections are to be
mounted outside or are to be exposed to any form of weathering then these
connections must be additionally weather proofed. The accessories supplied
do NOT offer any form of IP rated protection.
6)
The rope light should
not
be switched on while on the roll, in a tight coil or
in very close proximity to other LED ropes. This can lead to overheating and
damage to the product.