SPECIFICATIONS
Length:
24.25 inches
Width:
20 inches
Height:
48 inches
Weight:
85.5 pounds
Speed:
175 Std.
Pad Diameter:
17 inches or 20 inches
Drivers:
16 inches and 19 inches
Drive Motor:
1.5 HP, 120V, 12A, 60 HZ
Power Cord:
14-3 ST, 50 feet
SAFETY
Read and understand the manual
before operating this machine.
Do not operate in explosive areas or use near
flammable liquids or gases or dust.
Attach only to properly grounded outlet.
Do not expose to rain. Store indoors.
Do not operate the machine with a damaged cord
or plug.
Do not block or disconnect the safety lever.
Do not leave the machine plugged in while
unattended.
Unplug the machine before servicing.
Do not put fingers under the pad or pad holder.
Unplug the machine before installing or removing
the pad.
Use only with suitable pads or brushes.
OPERATING INSTRUCTIONS
Check machine for damage to cord or
plug.
Use suitable pads or brushes.
To install or change the pad:
1. Unplug the machine.
2. Tip the machine back on the wheels.
3. Install brush or pad driver.
4. Center the pad on the pad driver.
To operate the machine:
1. Plug into a grounded outlet.
2. Release the handle and lower it.
3. The handle should be locked into a comfortable
position for the operator.
4. Press the safety lever and squeeze the trigger to
start the machine.
5. Do not operate in one place as damage to the
floor could result.
6. Do not operate the machine with the handle in
upright position.
7. Remove the pad after every use.
8. Store the machine with the pad or brush
removed.
9. Use only new or clead pads and reverse them
as needed.
Maintenance
To maintain appearance - wipe the machine with a
damp cloth after use.
WARNING
- Unplug the machine before servicing.
CHECK EVERY 250 HOURS OF USE.
1. Check the motor brushes for wear or excessive
arcing on the two speed machine.
2. Check the cord and electrical system.
3. Check the safety lockout on the trigger.
4. Check the wheels.
