●
This manual is only for reference and does not
ensure that the information is totally consistent
with the actual product. For consistency, see the
actual product.
1. Package Contents
Open the package, check the appearance of the
product for no obvious damage, and confirm the
item list for table 1-1 is consistent.
Table 1-1: Packing List
Component
Quantity
Remark
Vandal Dome Network Camera
1
Setup & Support Insert
1
Installation Location Sticker
1
T15 Screwdriver
1
Large Dome
T10 Screwdriver
1
Mini Dome
Stainless Self-Tapping Screw
PA4.0×30mm
3
Swell Plastic Button
φ5.6×29mm
3
Waterproof Rubber Seal
1
Network Access Port Protective
Cover
1
Terminal Block
1
Optional
2. Device Structure
Camera Dimensions
Note: Different devices may have different dimensions;
please refer to the actual product.
Figure 2-1: Dimensions of Mini Dome (Units: mm)
Figure 2-2: Dimensions of Large Dome (Units: mm)
3. Device Installation
Warning: To avoid moisture influence, install
the dome cover at least half an hour after the
camera is installed and powered on.
The Vandal Dome Network Camera can be
installed on the ceiling or wall. This guide
describes how to install the camera on the
ceiling.
Installation Steps
1.
Use the T15 (large dome) or T10 (mini dome)
screwdriver in the accessory package to
unscrew the three screws on the dome cover.
Open the camera, as shown in figure 3-1.
Figure 3-1: Opening Camera
Large Dome
Mini Dome
2.
Attach the installation sticker to the ceiling.
Drill three holes as indicated by the sticker.
Remove the sticker. Drive the swell buttons
into the holes.
3.
Use the three self-tapping screws to fasten
the camera on the ceiling as shown in figure
3-2.
