EAE EE-6435BWF, Инструкция по установке, эксплуатации и ремонту

Страница: 27 / 55

Installation, Operation and Parts Manual
EE-6435BWF
27
5.2 Descriptions of control panel
5.3 Operation instructions
The lift must be only used in a static position for lifting and lowering vehicles.
Only use this lift on a surface that is stable and capable of sustaining the load. Do not install the lift on any asph alt surface.
To avoid personal injury and/or property damage, permit only trained personnel to operate the lift. After reviewing these
instructions, get familiar with lift controls by running the lift through a few cycles before loading vehicle on lift ing platform.
Caution:
Before raising, make sure vehicle is neither front nor rear heavy and center of balance should be centered over the lift.
Before push the button for lowering, pay careful attention that all personnel and objects are kept clear.
POS. Name Function
FA Alarm buzzer Low height warning
QS Power switch Power on/ off
HL Power indicator Display if electricity is connected
SB1 UP button Control the rising movement
SB3 DOWN I button Control the initial lowering movement
SB2
Safety lock
/DOWN II
button
1.1 In case the clearance between the platform and the
floor is more than 300mm, push DOWN II button to lock
the platform.
1.2 In case the clearance between the platform and the
floor is less than 300mm, push DOWN II, the platform
will continue lowering to the lowest position which
accompanies with acoustic alarm.
SB4 Reset button
As the lift is equipped with ‘out of level protection
system’, in case one of the steel cables is slacken, the
control buttons will stop functioning. In this case the
operator can push this button and DOWN button to
lower the platform.
SA1 Selection switch Select using wheel-support lift or wheel-free jack.