EA EA-HV 900 Series, Руководство пользователя

Страница: 14 / 18

© EA Elektro-Automatik, DE-41747 Viersen, Helmholtzstr. 31-33, Tel. 02162-3785-0, Fax. 02162-16230
14
Analogue interface
Pin connection on the analogue interface, Sub-D 15 pole
1 0V-Reference
2 + Reference (0...10V)
3 UPS (Input preset voltage potentiometer 0...10V
4 UPOT (output preset voltage potentiometer 0...10V
5 IPS (Input pre set current potentiometer 0...10V)
6 IPOT (output pre set current potentiometer 0...10V)
7 IMON (output actual value current 0...10V)
8 UMON (output actual value voltage 0...10V)
9 SB (Standby) control input: +5V = OFF (standby), open = ON
10 GND (GND/0V for external programming)
11 LOCK (safety loop / inhibit for HV load)
12 +5V output (for standby mode connect to pin 9)
13 N.C.
14 +15V output
15 N.C.
Fundamental settings for normal operation
For normal operation the following connections must be carried out on the analogue interface:
Pin 3 - Pin 4,
Pin 5 - Pin 6,
Pin 10 - Pin 11
These connections are already made at the included Sub-D plug.
Output terminals on the rear side
HI (HV socket) + or – output on the central contact, depending on
polarity (standard is +). The screen is connected to the
safety ground PE and may never be connected to the load.
LO (black) – output
(yellow) PE safety earth, return path for the load
Interfaces (according to setup)
24-pole socket IEEE bus interface (if equipped)
9-pole Sub-D connector RS-232 interface (if equipped)
15-pole Sub-D connector Analogue interface (must always be plugged)
RJ45 connector Ethernet port (if equipped)