EA Technology UltraTEV Monitor, Руководство по эксплуатации

Страница: 75 / 112

EA Technology UltraTEV Monitor
TM
Operating Manual 2178L014
72
16.4.2 Substations
Notice, to create a substation it is required to navigate to the substation list screen through a
corresponding Client and not from the top navigation menu. To create a new substation, from the
substation screen, click on the Create New Substation
button.
The screen shown in Figure 62 will then be displayed. Fill in the details for the substation, the only
required field is a name, denoted by the red asterisk. The source frequency will be in Hz and will be
either 50 or 60 depending on your region. The voltage fields are in kV.
Figure 62: Creating a new Substation
After inputting the substation details, you are taken to the substation layout screen. Each substation
has a layout that is used when creating an installation. This layout is defined when a new substation
is created. Once a substation has an active installation on it, the layout cannot be edited. Figure 63
shows the substation layout screen.
The substation layout is a plan view of a typical piece of Medium Voltage (MV) switchgear. The
bottom of the diagram is the front; the top of the diagram is the back and the middle of the diagram
represents the top of the switchgear.