E2S BExS110D-SIL, Инструкция по эксплуатации

Страница: 13 / 19

E2S Warning Signals Impress House, Mansell Road, Acton, London W3 7QH www.e2s.com Tel: +44 (0)208 743 8880
Document No. D210-00-651-IS Issue 1 13-01-23 Sheet 13 of 13
22) Product Coding for Fault Resistor and Customer EOL Resistor
The customer is able to identify the resistor values chosen on purchase from the product code.
This is represented by the last three characters:
BExS110DFDC024AB1S1R- AFZ
•
The first A character denotes the value of the Fault Resistor (FR) Default value is 2.2 k
Ω (Code = A)
unless an alternative
value is requested when ordering.
•
The second F character denotes the value of the Current Sense Resistor (CSR) Default value is 3.3 k
Ω (Code = F) unless
an alternative value is requested when ordering.
•
The third Z character denotes the value of the unit End Of Line Resistor (EOL) By default no EOL is fitted (Code = Z) A
factory fitted EOL resistor can be specified when ordering.
The values of resistors available are shown in table 5 below.
Code Resistor Value Three digit resistor coding as follows.
BExS110DFDC024AB1S1R - AFZ
Example of a custom requirement resistor coding:
BExS110DFDC024AB1S1R - GEF
Where the (FR) Fault Resistor is (G = 3.9 kΩ)
(CSR) Current Sense Resistor is (E = 2.7 kΩ)
(EOL) End Of Line resistor is (F = 3.3 k
Ω)
Two digit resistor coding on other units.
BExS110DFDC024AB1S1R - AZ
Where the (FR) Fault Resistor is (A = 2.2
kΩ)
(EOL) End Of Line resistor is (Z = none fitted)
A 2.2
kΩ
B 1.0
kΩ
C 1.5
kΩ
D 1.8
kΩ
E 2.7
kΩ
F 3.3
kΩ
G 3.9
kΩ
H 4.7
kΩ
J 5.6
kΩ
K 6.8
kΩ
L 8.2
kΩ
M 11
kΩ
Z None Fitted
Table 5: Resistor Value code
Note
: Customers who have previously acquired BExS110D-SIL sounders with the two-character resistor code system ( -XX ) may
continue to use their E2S product code reference to repeat purchase orders. In the two-character code, the first character denotes
the value of the Fault Resistor (FR) and the second character denotes the value of the EOL resistor.
Note : To utilise the full monitoring functionality the 4-wire configuration is recommended. An EOL resistor is not required for this
configuration.
The alternative 2-wire configuration requires an EOL resistor to be fitted. The EOL resistor can be specified during ordering and
factory fitted or selected and fitted during the alarm horn sounder installation.
See section 11 for EOL resistor location and wattage requirements. E2S recommends a value of 2.2K Ohm. If an alternative value is
required, please see section 18-2.
Both the (FR) Fault Resistor and (CSR) Current Sense Resistor are factory fitted and cannot be user replaced.