E2S BExCS110-05D-P, Инструкция по эксплуатации

Страница: 6 / 16

European Safety Systems Ltd. Impress House, Mansell Road, Acton, London W3 7QH www.e2s.com Tel: +44 (0)208 743 8880
Document No. D210-00-601-IS Issue 8 12-09-2022 Sheet 6 of 7
14. Settings
14.1 Tone Settings
The sounders have 32 different tones that can be selected for
the first stage alarm. The sounders can then be switched to
sound second and third stage alarm tones. The tones are
selected by operation of a DIP switch on the pcb for both DC
and AC units. The tone table D210-95-001-IS shows the switch
positions for the 32 tones and which tones are available for the
second and third stages. To operate the sounder on stage one
simply connect the supply voltage to the normal supply
terminals (+ve and –ve for DC units, L and N for AC units).
Refer to wiring schematics D210-06-601 (DC) or D210-06-605
(AC).
Default =
Tone 1
0 0 0 0 0 0
(ON = 1, OFF = 0)
Figure 8: DIP switch configuration
14.2 Volume Control
The output level of the BEx sounder can be set by adjusting
the volume control potentiometer (see Fig 10a/10b). For
maximum output, set the potentiometer fully clockwise.
BExCS110-05D-P AC
Fig.10a Location of Volume Control Potentiometer
BExCS110-05D-P DC
Fig.10b Location of Volume Control Potentiometer
Warning - High noise levels above 85dB(A)
during operation. High levels of noise may
cause hearing loss, wear suitable ear
protection when equipment is in operation.
Volume Control
Potentiometer
Volume Control
Potentiometer