e2-Live Home Automation
Edit by Shine Lo
5
Setting iPower
Set up before using :
ID & position of remote button
Main function is to be controlled wirelessly by all kind of remote controller of
e2-Live.
General functions :
For connected device, which does not need to know the status of power, or judge
the function.
Tools required:
RC -07 scenario remote control, the first zone to third zone
RC -09 intelligent remote control, the first zone
HT -100 LCD remote control, the first zone to fifth (except zone 1 to 7 )
Itouch lighting / curtain / power supply area (except power zone 1 to 7)
RP -20 software, the first zone to fifth (except fifth zone no. 1 to 7)
iPower can be set at any position for remote control
Actions before setting::
1. Firstly set up the remote ID, for example: RC -07 / RC 07 / RC-09 must be set up a four-digit ID;
itouch or RP -20 software is need to define the four-digit ID through software.
2. Determine iPower's 1 ~ 3 circuits to corresponding position.
3. Determine the connected device accept remote control “All off”.
Setting Description:
1.Press and hold the position of wanted circuit, such as the first one.
2.Take a paper clip to poke tact switch in the hole, until the red LED constant light up.
3. Pick up the setting of the Remote Control, press the wanted number, then press “ON” to not
accept the "All off" control, press “OFF” to accept the "All off" control.
4. Red LED starts flash (up to 7 times) indicates the setup is successful.
6. After entering the setting mode, there are 15 seconds to setting, if red LED has extinguish that
means setting unsuccessfully.
