3
Qwik Install
STEP 1:
Install The Battery
Remove any screws attaching holding plate to enclosure. Connect bat-
tery wires from controller to battery terminals.
Observe proper polar-
ity
. Gently lift holding plate and insert battery into enclosure with termi-
nals toward right hand side. Secure holding plate with 7 screws.
STEP 2:
Mount the EZ-Base
Choose a mounting location with good line of sight to the remote loca-
tions. Install two bracket pieces to back of enclosure using 4 screws.
The bracket can be mounted to a wall or to an existing pole up to 2”
diameter. The EZ-Base can also be mounted indoors if desired.
TECH TIP:
Microwaves travel in straight lines and they lose
strength quickly when going thru buildings and trees. If there are
objects in the microwave path, then useable distance will be reduced.
2.4GHz penetrates objects better than 5GHz
.
STEP 3:
Install a CAT5 cable between the included POE inserter/
power supply , through the RJ45 Feedthru and to the bottom RJ45 con-
nector on the controller labeled POE IN. CAT5 cable can be up to
300’ (100m) in length. NOTE: We highly recommend using shielded
CAT5 cable for outdoor runs to prevent EM surges from lightning from
damaging the Ethernet port on the wireless device.
