E-Z-GO ST SPORT, Руководство пользователя и сервисное руководство

Страница: 35 / 84

OPERATION AND SERVICE INFORMATION
Page 15
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notes, Cautions and Warnings.
B
B
SUN TOP & WINDSHIELD
(If Equipped)
The top does not provide protection from roll
over or falling objects.
The windshield does not provide protection
from tree limbs or flying objects.
The top and windshield provide some protection from
the elements; however, they will not keep the operator
and passengers dry in a downpour. For complete protec-
tion from the elements, a weather enclosure can be
installed. This vehicle is not equipped with seat belts
and has not been designed to provide roll over protec-
tion.
Clean windshield with lots of water and a clean cloth.
Minor scratches may be removed using a commercial
plastic polish or Plexus plastic cleaner available from the
Service Parts Department.
VEHICLE CLEANING AND CARE
VEHICLE CLEANING
To reduce the possibility of severe injury or
vehicle damage, read and understand all
instructions supplied by manufacturer of pres-
sure washer.
When pressure washing exterior of vehicle, do not use
pressure in excess of 700 psi (4800 kpa). To reduce the
possibility of cosmetic damage, do not use any abrasive
or reactive solvents to clean plastic parts.
It is important that proper techniques and cleaning mate-
rials be used. Using excessive water pressure may
cause severe injury to operator or bystander, damage to
seals, plastics, seat material, body finish or electrical
system. Do not use pressure in excess of 700 psi (4800
kpa) to wash exterior of vehicle.
Clean windshield with lots of water and a clean cloth.
Minor scratches may be removed using a commercial
plastic polish or Plexus
®
plastic cleaner available from
the service parts department.
Normal cleaning of vinyl seats and plastic or rubber trim
requires the use of a mild soap solution applied with a
sponge or soft brush and wipe with a damp cloth.
Removal of oil, tar, asphalt, shoe polish, etc. will require
the use of a commercially available vinyl/rubber cleaner.
The painted surfaces of the vehicle provide attractive
appearance and durable protection. Frequent washing
with lukewarm or cold water and mild detergent is
required to preserve the painted surfaces.
Occasional cleaning and waxing with non-abrasive prod-
ucts designed for ‘clear coat’ automotive finishes will
enhance the appearance and durability of the painted
surfaces.
Corrosive materials used as fertilizers or for dust control
can collect on the underbody of the vehicle. These
materials will cause corrosion of underbody parts unless
flushed occasionally with plain water. Thoroughly clean
any areas where mud or other debris can collect. Sedi-
ment packed in closed areas should be loosened to
ease it’s removal, taking care not to chip or otherwise
damage paint.
If the engine does not start or runs improperly after washing,
remove the spark plug wires (by pulling the spark plug boots,
never the wires). Dry all connections with forced air. Reinstall
the wires.