E-Z-GO ST 480 2007, Руководство пользователя и руководство по обслуживанию

Страница: 24 / 134

OPERATION AND SERVICE INFORMATION
Page 6
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
snaps in place. Never operate the winch unless
the clutch is engaged.
Have all persons and pets leave the area while
operating winch. Never allow anyone to remain
in the vehicle.
To prevent damage to the wire cable, never
hook the cable to itself.Always use a nylon sling
(Ref Fig. 8 on page 6) (Ref Fig. 9 on page 6).
Stay clear of the winch, the cable and the cable
hook. Place a heavy cloth, jacket or blanket
over the cable to act as a damper should the
cable break when operating the winch (Ref Fig.
9 on page 6).
Fig. 8 Do Not Hook Cable to Itself
Remember that the winch operation will drain
the battery and may leave insufficient power to
start the vehicle.
When operating the winch, keep the entire area
in view.
Fig. 9 Use a Nylon Sling and Install a Damper when
Winching
Never release the free spool clutch while the
cable is under load.
Never work around the winch drum or the
winch cable while it is under tension.
Unplug the winch switch before working on the
winch drum in order to prevent inadvertent
operation.
When operating winch, take up slack slowly.
Stop winch before cable becomes tight and
inspect all winching connections. Check winch
attachment, hook attachment, nylon sling (if
required) and load attachment.
Do not pull at an angle. This will cause the wire
cable to pile up on one end of the winch. This
may jam the winch causing damage to the
cable and/or the winch. Pulling the vehicle at an
angle can cause damage to the front suspen-
sion and may cause the vehicle to overturn.
When pulling vehicle, pull straight only (Ref Fig.
10 on page 6).
Fig. 10 Do Not Pull at Angle
If the vehicle is being used as an anchor to
winch a load, it should have the parking brake
set and chocks installed on all wheels.
Never use the winch to lift people or other over-
head loads.
Do not use the winch to secure loads. Use a tie
down designed for the job.
Do not apply shock loads to the winch.
Do not attempt to modify or weld the winch.
Ref Wca 2
Nylon
Sling
Damper
Ref Wcd 2
Correct
Incorrect
Ref Wps 2