E-Z-GO ST 480 2007, Руководство пользователя и руководство по обслуживанию

Страница: 34 / 134

OPERATION AND SERVICE INFORMATION
Page 16
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings
.
Some items must be serviced more frequently on vehicles used
under severe driving conditions
POWERTRAIN MAINTENANCE
Access powertrain by raising or removing the seats and/
or dump bed.
To prevent severe personal injury or death,
observe the following:
Always install a positive stop to prevent
dump bed from unexpectedly falling.
Wrap wrenches with vinyl tape to prevent
the possibility of a dropped wrench ‘shorting
out’ a battery, which could result in an
explosion.
Prevent accidental starting by removing and
grounding spark plug wires and disconnect-
ing battery at negative terminal before ser-
vicing.
Some service procedures may require the vehicle be
lifted. Refer to “Lifting the Vehicle” for proper lifting proce-
dure and safety information.
Removing Debris
To prevent possible burns, engine parts should
be kept clean to reduce risk of overheating and
ignition of accumulated debris.
After every off road use, allow to cool and then check for
a build up of dirt and debris in the air intake and cooling
fins. Dirt and debris may clog the engine’s air cooling
system. Clean areas shown to prevent engine damage
(Ref Fig. 22 on page 16). Keep linkages, springs and
controls clean. Keep area around muffler free of any
combustible material.
Fig. 22 Cleaning Cooling Fins and Air Intake
Replacing the Fuel Filter
To prevent a possible explosion, do not smoke
near the fuel tank or in an area where gasoline
is being handled. Do not perform procedures
involving fuel system near open fire or electrical
items which could produce a spark.
Do not handle gasoline in an area that is not
adequately ventilated.
Always wear safety glasses to prevent possible
eye injury from gasoline or gasoline vapor.
To replace fuel filter, use a pair of pliers to move clamps
off ends of filter and pull filter up higher than the fuel
pump to reduce the amount of gas that will spill (Ref Fig.
24 on page 17). Remove hose coming from fuel tank first
and plug. Remove filter from hose going to fuel pump
and discard.
Orient direction of new fuel filter according to the FLOW arrow
on the side of filter.
Install new fuel filter and reposition the clamps over the
inlet and outlet.
Oil Capacity
Engine oil capacity is approximately 1 1/2 quarts (1.4
liters) when changing oil and filter.
Oil Recommendations
The oil must be high quality detergent oil classified ‘For
Service SF, SG, SH, SJ’ or higher. Do not use special
additives and do not mix oil with gasoline. The selection
of oil viscosity is dependent upon the climate in which the
vehicle will be used. Most vehicles require SAE 30 oil;
however, vehicles used in cold climates will require a
multi-viscosity oil (Ref Fig. 23 on page 17).
Air
Intake
Cooling
Fins
Ref Cai 2