OPERATION AND SERVICE INFORMATION
Page 21
Owner’s Guide
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notes, Cautions and Warnings.
B
B
metal surfaces that have been cleaned must be
primed and painted with a corrosion resistant paint.
.
Fig. 24 Battery Removal
9. Replace the batteries, using the portable lifting device,
starting with the battery located at the back of the bat-
tery tray (4), making sure that it is positioned as
shown.
Fig. 25 Battery Placement & Orientation
10. With the J-bolts in the battery hold-down and held in
place by the hex nuts on the end of the threaded por-
tion; carefully position the battery hold-down and the
battery strap, guiding the J-bolts between the batteries
(it may be necessary to tip the batteries slightly) and
into the slots in the battery tray. Tighten the hex nuts
on the J-bolts making sure that the J-bolts are se-
curely hooked in the battery tray. Tighten the J-bolt
hex nuts to 62 - 80 in. lbs. (7 - 9 Nm) torque.
11. Install the two Pan Head Torx drive screws through
the ends of the battery strap into the holes on the vehi-
cle frame and tighten them to 80 - 97 in. lbs. (9 - 11
Nm) torque.
Fig. 26 Battery Components
12. Inspect all wires and terminals and clean any corro-
sion from the battery terminals or wire terminals with a
solution of baking soda and water, using a wire brush
to completely remove corrosion if required.
13. Carefully replace the wires on the battery terminals as
shown (Ref. Fig. 27). Make sure to reconnect the main
negative (-) battery cable, BL-, from the controller
last.
14. Tighten all battery terminal hardware to 62 - 80 in. lbs.
(7 - 9 Nm) torque.
15. Protect the battery terminals and battery cable termi-
nals with a commercially available protective coating.
To prevent battery explosion that could result
in severe personal injury or death, extreme
care must be used with aerosol containers of
battery terminal protectant. Insulate the metal
container to prevent the metal can from con-
tacting battery terminals which could result in
an explosion.
FRONT
Hex Nut
Washer
Battery Hold Down
Battery Strap
J-bolt
Battery
Battery
Tray
Содержание RXV FREEDOM 2008
