ELECTRICAL COMPONENTS & WIRING
Page K-17
Repair and Service Manual
Read all of Section B and this section before attempting any procedure. Pay particular attention to all Notices, Cautions, Warnings and Dangers.
B
B
Horn Button Replacement
Make sure that the vehicle key switch is in the ’OFF’
position and the key has been removed.
To access the horn button switch for replacement, the
lower and upper rocker panel on the driver side must be
removed as well as the top portion of the cup holder (ref:
Section B).
1. Remove the horn button cover using a flat blade to
work the cover off of the switch.
2. Pull the upper corner of the floormat down to expose
the switch retaining nut.
3. Remove the nut that secures the horn button.
4. Remove the horn button switch from the floor1board.
5. Install the new horn button switch through the floor-
board and secure in place with the hex nut supplied
with the switch.
6. Disconnect the horn button wire harness from the
accessory harness in the lower portion of the cup
holder.
7. Before removing the old horn button wire harness
route the new one along the same path, removing the
old harness clips just before the new clips are placed
on the frame.
8. Route the new horn button harness up through the
flap in the front splash shield and connect it to the
accessory harness.
9. Replace the floormat and install the horn button cover.
Reinstall the rocker panels and the top portion of the cup
holder.
Horn Replacement
Make sure that the vehicle key switch is in the ’OFF’
position and the key has been removed.
The horn is located under the front cowl, mounted to the
frame.
1. Disconnect the accessory wire harness from the horn.
2. Remove the hex head bolt that secures the horn to the
mounting bracket.
3. Position the new horn with the opening to the front of
the vehicle and secure in place with the hex head bolt.
4. Connect the accessory wire harness to the horn.
Top Mounted Brake Light Replace-
ment
Tool List
Qty.
Ratchet ........................................................................1
Torque Wrench, in. lbs. ...............................................1
Torx Bit, T-15................................................................1
Make sure that the vehicle switch is in the ’OFF’ position
and the key has been removed.
1. Remove two torx head screws that secure the brake
light assembly to the top.
2. Pull the brake light out away from the vehicle top, dis-
connect the wires from the wire harness.
3. Connect the wires from the new brake light to the wire
harness.
4. Install the light assembly into the opening in the top,
making sure that the wires are not pinched between
the the light housing and the top openeing.
5. Install two torx head screws and tighten to 13 - 22 in.
lbs. (1.5 - 2.5 Nm) of torque.
Top Mounted Brake Light Bulb
Replacement
Tool List
Qty.
Phillips Screwdriver .....................................................1
Make sure that the vehicle switch is in the ’OFF’ position
and the key has been removed.
1. Remove two phillips head screws.
2. Remove red lens.
3. Pull straight out on the bad light bulb.
4. Install a new #921 wedge base bulb.
5. Replace red lens and secure with phillips head
screws.
