E-TON Beamer & Beamer, Руководство пользователя

Страница: 14 / 29

Page 13 Rev 3.01 8-0904
Electrical Battery
The unit’s battery is located under the floor board
mat and supplies electrical power to the unit. The
battery is a 12 volt gel acid type that contains no
liquid electrolyte. The battery should be removed
from the vehicle when stored for extended
periods and charged before being replaced in the
unit. Use a trickle charger set at 12 volts to
recharge the battery to full charge before
replacing it in the unit.
When reinstalling the battery, be sure to connect
the red cable to the positive (+) terminal and the
black cable to the negative (-) terminal.
The battery should be replaced every three years
or when it no longer holds a charge.
Do not expose the battery, for extended periods
of time, to freezing temperatures. If the battery
has been frozen it will need to be replaced.
There is an inline fuse on the positive lead of
the battery to protect the wiring system from
over loads. If your starter motor will not turn
over and the battery is fully charged, check
the inline fuse on the unit.
Replace the fuse with a 7A fuse.
C.V.T. Filter
This unit is equipped with an air filter for
the C.V.T. transmission. It is located on the
left-hand side of the engine, just ahead of
the kick starter spindle. The filter will
accumulate dust and must be cleaned
periodically to maintain normal vehicle
operations. Inspect and clean the filter
every 3000 miles, more frequently if
operated in a dusty environment.
To clean the filter, remove the two cover
bolts and remove the filter. Clean the filter
element in a non-flammable solvent and let
dry completely before reinstalling. Replace
the filter element and the cover.
FRONT FORKS
Check the front forks of your vehicle for signs
of damage or leaking oil. If either is noticed,
return the vehicle to your dealer for service.
Copyright ©2008-2009 ETON America, all rights reserved.