E-TON Beamer & Beamer, Руководство пользователя

Страница: 11 / 29

Page 10 Rev 3.01 8-0904
Engine Oil
Your vehicle uses 2 cycle oil to lubricate the
engine. The oil tank is located under the seat at
the front of the unit. Oil is drawn from this tank by
an oil injector pump when the engine is operating.
Oil Level Warning Light
The unit is also equipped with an oil level
indicator lamp. The lamp will light when the oil
level in the tank is low. When the lamp is lit you
MUST refill the oil tank.
DO NOT allow the engine to operate with an
empty oil tank. Doing so will result in
extensive damage to your engine. This
damage is not covered under the warranty
.
Check the oil tank level manually every 500 miles
of operation.
The oil tank is located under the seat in the front
of the vehicle. It is accessed by removing the Oil
tank cover retaining screw and lifting the
cover. The oil tank capacity is 1.1 liters, 1.2qt.
Fill the tank with high quality JASO FC grade
2 cycle injector engine oil. Using lower grade
oil can cause exhaust smoke and result in
damage to your engine.
IMPORTANT NOTE:
Your first tank of fuel should be a pre-mix
fuel with a 50:1 fuel to oil ratio. This will
insure the engine is lubricated and give the
oil pump time to bleed any air from the oil
line that may have occurred during shipping.
If your unit is creating excessive smoke
from the exhaust insure that you have
used a JASO FC grade 2 cycle injector
oil in the tank. If you are sure your oil is
of the correct grade, your oil pump may
need adjustment. The oil pump must be
adjusted by an authorized ETON Dealer.
Copyright ©2008-2009 ETON America, all rights reserved.