E-TECH ET8 V4 CONTROL PANEL - USER MANUAL
26
SYMPTOM
POSSIBLE CAUSE
REMEDY
Zone light on or long beeps when
Arming
One or more Zone Detection Devices
(e.g., PIR, Reed Switch) may be
Unsealed
Close door or window, find the cause
of movement
10 beeps from keypad
MAINS light flashing
BATTERY light flashing
The mains power may be off,
...or the panel’s backup battery may be low,
...or a Radio Device battery may be low.
Make sure the plug pack is plugged in
and the power point is turned on.
Call your installer.
1 long beep from keypad
Invalid keypad entry
Press E button and try again
2 second siren at the end of Exit
Delay time
A zone was Unsealed at the end of Exit
Delay time
Disarm the panel and check all zones
Strobe light is flashing
There has been an alarm
Reset the alarm by Disarming the
panel and check the Alarm Memory
Siren sounds while the panel is
Disarmed
A 24 hour zone has been triggered.
E.g, Siren Tamper, Box Tamper, Panic
Button.
Reset the alarm by Disarming the
panel and call your installer.
EXCLUDE light is flashing
A zone/s has been Excluded
TAMPER light flashing
The 24 hour Tamper input has
triggered
Call your installer
ALARM MEMORY light is flashing
There are alarms in memory
To clear the ALARM MEMORY light,
view the Alarm memory otherwise the
light will clear next time you Arm the
panel.
Cannot enter Program Mode
The panel is Armed.
Only the Master Code can enter
Program Mode.
Disarm the panel before attempting to
enter Program Mode.
Try again using the Master Code.
TROUBLESHOOTING
