E-TECH ET8 V4 CONTROL PANEL - USER MANUAL
21
* The Primary and Secondary telephone numbers are normally only
used for central station monitoring. These numbers can only be
programmed in Installer Program Mode.
** The Follow Me Telephone Number replaces the Primary AND
Secondary telephone numbers.
MONITORED PREMISES
AUDIBLE MONITORING
TELEPHONE LINE
MOBILE TELEPHONE
FIXED TELEPHONE
AUDIBLE MONITORING
The ET8 can also be programmed to send
audible messages to any telephone or mobile
phone.
When programmed for audible monitoring, the
ET8 calls a pre-programmed number (or
numbers) and sounds a series of beeps over
the phone. These beeps can identify the zone
or zones which caused the alarm and well as
several other alarm types.
FOLLOW ME TELEPHONE NUMBER
The Follow Me Telephone Number is the
telephone number to which the ET8 sends
alarm reports when Audible Monitoring is
enabled.
The Follow Me Telephone Number can be
changed by the user in User program Mode.
If the Follow Me Telephone Number is
programmed, the Primary and Secondary
telephone numbers are ignored, even if
programmed. (When Audible Monitoring is
enabled).
See page 19 for information on programming
the Follow Me Telephone Number.
AUDIBLE MONITORING SEQUENCE
When triggered by an alarm, the ET8 will dial
the programmed telephone number/s and
output the audible message for 45 seconds or
until it is acknowledged.
ACKNOWLEDGING THE ALARM
The person receiving the call can then
acknowledge the alarm by pressing the
key
on their telephone. Press the
key for at least
2 seconds during pauses in the audible
message.
If the alarm is not acknowledged, the keypad’s
LINE light will flash continuously until the panel
is next Armed.